• Creator
  • #2027456
    Avatar Of `Janet Elmore`janet elmore
    Post count: 19

    I recently was given a Stanley plane that has a through crack on the side.  Is it possible to weld it or is it just scrap now?

Viewing 2 reply threads
  • Author
    • Avatar Of Mike In TnMike in TN
      Post count: 301

      Most planes are made of cast iron and that is normally brazed. I have seen some good plane repairs and lots of bad ones. Sometimes, depending on where and how bad the damage is, the plane can be used without repair. If the break goes through the mouth then it will probably flex during use which will probably render it useless except for replacement parts. I would have to check it over closely to determine if the event that caused the obvious damage didn’t cause additional, not so obvious damage such as a warped sole. Any brazing is definitely best left to someone with a well developed skill set in working with metals.

      Obviously, the more common the plane is,  the less effort could be justified in trying to restore it.

    • Avatar Of Bill M.Bill M.
      Post count: 2

      Welding Cast Iron

      Cast iron can be welded, but special care is needed in preheating the part and slow cooling afer the weld is completed.  Such a repair might be justified on a very rare plane.  For a common plane, brazing might be a better option to create a good user.

    • Avatar Of Woodwhittlerwoodwhittler
      Post count: 3

      All depends on what type of plane it is whether its worth the time and effort to repair it.  Any pics?

Viewing 2 reply threads
  • You must be logged in to reply to this topic.